eufy Robot vacuum cleaner with cleaning function, RoboVac G10 Hybrid, intelligent dynamic navigation, 2-in-1 vacuum cleaner and robot vacuum cleaner, 2000 Pa suction power

About this item hair dryer To solve the charging problem, turn off the RoboVac. Remove the battery cover and check that the battery is properly connected. Disconnect and reconnect the battery if necessary. If the surface of the battery is hot, wait until it cools down. After reconnecting the battery, replace the battery cover. Turn on and start RoboVac to make sure it can navigate properly and complete a clean cycle without a hitch If the suction power is low, please check whether the suction inlet is clogged. Empty the dust container and clean the filters using a vacuum cleaner or cleaning brush. Replace the filter/brush to see if this improves suction performance. Check if the filters are wet due to water or other liquids on the floor. Allow filters to air dry completely before use If the device has a problem with the S6, please turn off RoboVac. Clean the drop sensors located at the bottom of the RoboVac, near the bumper, with a dry cloth to make sure they are not covered with dust. Turn on RoboVac, place it in a new location near the original location where the problem occurred, and then start RoboVac to see if the issue has been resolved › See more product details

eufy